Vehicle Description
RP Exotics is pleased to offer this incredible 1969 Ford Bronco.
Finished in Infinity Copper over a custom black interior, this
Bronco is a showstopper. This beautiful classic has received over
$100k in modifications and has been built from the frame up. From
engine modifications to interior customizations, this low miles
Bronco has been well maintained and is ready for a new home! Below
is a list of all modifications made on this amazing 1969 Ford
Bronco!
EXTERIOR
-Infinity copper 3K paint.
-Soft-top, one-of-a-kind design, Stainless supports.
-Hardtop - rhino lined, headliner, Stainless hardware, Tinted rear,
Hydraulic lift, Tinted and split slider for sides!
-Custom profile fiberglass hood with hood pins (has stress
cracks).
-Recessed gas cap.
-Custom front and rear bumpers.
-Swing away spare tire.
-New glass and gaskets.
-80% of truck is lined with dyno mat (heat isolation).
-Rhino lined tub.
-Highjack lift integrated onto lift gate!
INTERIOR
-Door activated front and rear interior dome light with manual
override!
-Drivers side has dual JL Audio amps where 2nd gas tank was
located!
-Alpine deck (mounted in tuffy box console).
-JL audio 300/4 amp (amps mounted under seat).
-JL audio 500/1 amp.
-JL audio sub.
-JL audio separates with programmable crossovers.
-Dakota digital dash with all sensors.
-Alarm with remote door lock!
-Microwave sensor covers entire interior.
-Aluminum tunnel cover, swirl sanded, color and then cleared!
-Custom welded dash, defrost ducts added, acid etched and
cleared.
-Corbeau front bucket seats.
-Rear bench seat.
-Rear 4-point harnesses.
-10 point fully welded and padded cage.
-Window is reinforced with turnbuckets to roll cage.
-Lockable tuffy boxes - glove, center, behind rear seat keyed the
same.
-Dual interior courtesy lights with override.
-1500W A/C inverter.
-4 12v outlets.
TRANSFER CASE
-All new internals.
-HD output shaft unit.
-Twin stick controls.
REAR AXLE
-35 spline, big bearing, Currie 9inch housing, axles, and
carrier.
-2'' wheel spacers.
REAR PUMPKIN
-ARB air.
FRONT AXLE
-Dana 44.
-Upgrade U joints.
-2'' wheel spacers.
FRONT PUMPKIN
-ARB air.
CLUTCH
-Center force.
-Green machine starter.
-Transmission - 6 Speed manual.
New - Nv4500 Granny and 6th speed overdrive for highway use!
-302 V8 Power plant.
-Ford motorsport roller rockers.
-Dual chain roller.
-Trick flow heads.
-ARP fasteners.
-Chro-molly rings (at 800 rpm over boulders you need a strong
ring).
-Keith black pistons.
-Commander 950 TBI.
-High flow water pump.
-High flow oil pump.
-8Qt pan (at 1mph you need all the cooling you can get).
-Edlebrock intake.
-Custom headers.
-Mini CATs.
-Custom cam (too long for brake booster - hence hydraulic
booster).
-X pipe exhaust (all alum coated).
-Exhaust joints are compression fit if the pipes need to get
removed or replaced.
-Quiet mufflers.
-MSD electronic ignition.
-Mean green starter.
STEERING
-HD Saginaw.
-Oil cooler.
-F-150 box.
-Reinforced frame.
-Bullet proof linkage with upper knuckle conversion and AN
fasteners.
-Ididit tilt column.
BRAKES
-Hydro boost.
-Wilwood master.
-Proportion valve.
-Front slot disc.
-Rear disc.
-Modern foot pedal e-brake.
-Stainless lines!
SUSPENSION
-Dual long travel adjustable shocks on each corner.
-Limiting straps on all corners.
-Long travel radius arms on custom drop brackets.
-HD drop link with
