Vehicle Description
This custom 1963 Chevrolet C10 pickup is outfitted with a freshly
built 383ci stroker engine created from a 4-bolt main block. The
engine features long-tube Hooker headers, a CHF 40GPH electric
water pump, Holley 15 psi fuel pump and bypass regulator. All
braided AN fuel lines with AN filter. AN cooling lines with billet
thermostat housing and water pump outlet. Additionally, the engine
is fitted with COMP Cams tappet lifters and new pushrods, as well
as a 303-duration camshaft with 303 intake and 303 exhaust, 0.488
lift 144 lobe separation. The 383 also features a Weiand Warrior
intake manifold and aluminum dual-core radiator. Billet distributor
with 8mm wires and 6,500 rpm rev limiter, 6-quart oil pan, ARP Bolt
set, and the entire engine has all new seals and gaskets and less
than 60 miles since rebuild. Modern wiring and electronics have
been used throughout the truck, and this custom features climate
control. The pickup is equipped with air-ride suspension with two
5800 pumps, 7-gallon air reservoir, 10-inch air bags on all four
corners connected by 0.375-inch air lines and a seven-switch
controller.
