Here is a very nice Custom 1979 Chevy C10 Silverado Pickup
Some body panels are original such as the cab and doors, the bed is a southern bed that had no rust and has a good bit of custom options added such as flush tailgate with seat belt latches, flush rear tail lights, hidden hitch, new oak boards and all stainless fasteners. The front fenders were new GM fenders and painted to match inner fenders. The grill and headlight bezels are GM nos parts also. New Old Stock Emblems as well. This was a long bed truck when new but has been shortened and made into a short bed.
Has a GM NOS dash pad, NOS trim pieces, has a custom set of bucket seats, custom inner door panels and oak armrests. The headliner has been replaced with factory material and the visors have been recovered to match the door panels.
Has A/C, Power Windows, Power Locks, Tilt Wheel. Has a Kenwood AM/FM CD Stereo with two amplifiers and 5 speakers.
All steering, brakes and suspension components have been replace and or upgraded.
12 Bolt with 3.73 gears and Eaton Posi Unit with all new gears and bearings. Has upgraded Axles as well.
Tremec TKO-600 5-Speed Manual Trans with overdrive and Hurst Shifter.
548 Cubic Inch Big Block Engine built by Ohio Crankshaft with Mark III Merlin Block and Dart Pro 1 Ported heads. Has steel crank and rods and is a 9.75 to 1 compression ratio so it is very streetable and uses pump gas. Complete roller valve train which is all made by Comp Cams. This engine is close to 700 horsepower and really runs strong and is a pleasure to drive with the manual transmission. This engine from Ohio Crankshaft is over $11,000 as you can see on their website.
Wheels and Tires;
Centerline Billet Aluminum Wheels 15x10 in the rear and 15x8.5 in the front. Mickey Thompson 295/50r15 in the rear and 255/60R15 in the front.
This truck runs and drives excellent and only has 2000 miles on it since the total restoration.